Home » Produtos Estética » Opus Bulk Fill Flow APS

Opus Bulk Fill Flow APS

Flowable light-curing composite with low-shrinkage stress.

Easy insertion and adaptation
Base of posterior restorations in increments of up to 4mm

Benefits

Self-leveling:
It allows a perfect adaptation of the material to the walls of the preparation.

Smart thixotropy:
Antigravity action: perfect application to superior teeth.

Mechanical resistance:
With approximately 68% of mass fillers, the composite shows enough mechanical strength to be used under direct restorations. It should be coated with a dense-consistency composite.

Stability under ambient light:
Provides longer working time.

Curing depth:
Can be inserted in increments up to 4mm deep.

Compatibility:
With all classes of adhesives and methacrylate-based composites.

Recommendations

Basis of posterior restoration (class I and class II). Liner under direct restorative materials. Regularization/planification of the cavity preparation walls. Repair of small enamel defects. Repair of temporary materials in acrylic and composite.

Liner under direct restorative materials.

Regularization/planification of the cavity preparation walls

Repair of small enamel defects.

Repair of temporary materials in acrylic and composite.

Commercial Availability

Refill

• 1 syringe with 2g, available in shades A1, A2 and A3.

Step by step

Step 1 of 6

Prepare the cavity and maintain the tooth free from contaminants, preferably with absolute isolation.

Step 2 of 6

The application of phosphoric acid and dental adhesive must follow the protocol of the respective products used.

Step 3 of 6

Apply Opus Bulk Fill Flow APS into the cavity in 4mm increments. Start by applying the composite to the deeper zones of the preparation, dispensing the material so that the applicator tip is close or briefly above the layer that is being applied. We do not recommend submersing the applicator tip into the composite during insertion.

Step 4 of 6

Light cure each increment for 20 seconds.

Step 5 of 6

Fill the cavity preparation until there is 2mm or more left to the occlusal surface (cavosurface). This last layer should be restored with conventional composite or Opus Bulk Fill APS (FGM), which allows sculpting and catering to the masticatory mechanical demands. Light cure according to the manufacturer’s recommendations.

Step 6 of 6

Check for occlusal contacts, finish and polish the restoration. For finishing, you may use sandpaper disks Diamond Pro (FGM) or burs of fine grit. For polishing, we recommend using felt disks Diamond Flex (FGM) and polishing paste Diamond Excel (FGM).